Installation rear window

To learn more about our services to repair or replace your glass, please select from below. Rear windshield replacement Have damage to your rear auto glass? How do you replace a rear windshield? When you come to us for a rear windshield replacement, our technicians will: Inspect the damage carefully Remove the damaged glass Vacuum any debris and glass from the vehicle Insert a brand new rear windshield Ensure any defrost or technological capabilities are functional Clean all of the glass on your vehicle.

Trust the safety and reliability of Safelite. Back window replacement service. The convenience you deserve. Need us to come to you? Image 9: The lower ends of the upper windshield moldings are held to the body with a 8 sheet metal screw. Image The lower windshield corner moldings are held to the body with clip set PIN The clips are screwed to the cowl with a 8 sheet metal screw and the rear of the molding is screwed the back of the A-pillar with a 6 counter sunk sheet metal screw.

Be s ure the top opening of the corner moldings properly engages the upper stainless. Image The lower windshield moldings are held to the body with clip set PIN The large center and two small mid clips attach to the cowl screen or cowl with 6 sheet metal screws.

Image There are two clips included in PIN that include threaded studs. These clips are the two outer clips for the lower windshield moldings. The studs fit into corresponding holes in the cowl once the moldings are in place.

Image Carefully slide the lower windshield moldings onto the clips attached to the cowl screen or cowl. Image With the lower moldings slid onto the clips on the cowl screen, bow the moldings slightly and slide them into the lower corner moldings at the same time passing the stud of the outer clip through the holes in the cowl.

Find the studs under the dash board from the inside and install the supplied pal nut and tighten. You may even wait until this point to install the lower center clip making the installation even easier. Image Next install the center lower stainless connector PIN by snapping it over the top edge of the molding first and then over the lower edge. Image The rear glass moldings are held to the body with clips PIN These clips fit over the rear glass pinch weld at designated places around the opening.

You will note places where the pinch weld is only one thickness of sheet metal, making the clips easy to hammer into place. Image Install the rear glass gasket PIN so that the rubber flap is to the inside of the glass.

This gasket has molded corners that will match up to the upper corners of the glass. Clean and degrease an approx. Apply glass primer on the glass as shown in the figure then allow it to dry for approx. To prevent weakening of the primer adhesion, keep the bonding surface free of dirt, moisture, and grease. Do not touch the surface with your hand. If the sealant has come off completely in any one place, apply some primer, and allow it to dry for approx.

Apply body primer on the body as shown in the figure, then allow it to dry for approx. Verify that the gap at the upper and lower parts of the glass is within the specification shown in the figure, then press along the perimeter of the glass. Verify TCM configuration implementation necessity for replacement parts. Replacement part Configuration necessity Control valve body replacement Necessary